PC/104 LAN
.jpg)
|
|
|
PC104-ELC-2 |
|
|
The PC/104 Ethernet Ethernet Card is an efficient solution that provides system designers the flexibility to include Ethernet Ethernet functionality into any PC/104 based system, with minimal engineering resources. The 16-bit Ethernet Ethernet card features -40oC to +85oC extended operating temperature. It is fully IEEE802.3 compatible. The card delivers full duplex Ethernet data transmission at speed up to 10Mbps.
Installation is easy, the PC/104 Ethernet Ethernet card has built in RJ-45 connector, 10Base-T transceiver and optional BNC connector support 10Base-2. It can be installed under PnP and Jumper-less methods or using Jumper selection. The card is fully NE2000 compatible. It supports network operating systems (NOS) including OS/2 LAN, Novell NetWare and Microsoft Ethernet Manager. Features:
- PC/104 interface
- Full IEEE 802.3 compliant
- High Speed 10Mbps data transfer rate (up to 20Mbps in full duplex mode)
- Standard 10BASE-T RJ-45 port
- Optional 10BASE-2 coaxial connector
- Optional AUI port support for external transceiver
- Software compatible with Novell® NE-2000
- Support for 8-bit or 16-bit bus
- Jumper less mode and PnP mode capable
- Configurable with on-board EEPROM for jumper less mode
- Interface auto-detect
- Auto polarity correction for 10BASE-T
- Full duplex capable
- Build in 16K SRAM
- Improved performance with data pre-fetch function
- 3 levels of power down sleep modes
- Support 8 IRQs, 16 I/O base addresses
- RIPL boot PROM for remote boot and diskless operation (sold separately)
- 5 V operation
- 3.775" x 3.550" x 0.435" (with low profile RJ-45 jack)
- On board LED's for Ethernet and link activity
- Software drivers included*
Ordering Information:
| Models |
Built-in Connectors |
| PC104-ELC |
10Base-T (RJ-45) |
| PC104-ELC-2 |
10Base-2 (BNC Coaxial), 10Base-T (RJ-45) and AUI External Transceiver Connectors |
*Drivers Supported: - NetWare ODI DOS Client
- NetWare ODI OS/2 Client
- NetWare ODI Server
- OS/2 NDIS2 for Microsoft Ethernet Manager
- DOS NDIS2 for Microsoft Ethernet Manager
- Windows NT/95/2000 NDIS3
- WFW NDIS3
- Windows CE 3.0
- Linux 2.0 kernel
- Linux 2.1 and above kernel
- SCO UNIX
- PSOS UNIX
|
Ratings @ 25o C
| Parameter | Min | Max | Units | | Operating Temperature | -40 | +85 | oC | | Relative Humidity (non-condensing) | 0 | +90 | o/o | | Voltage Requirement | 4.75 | 5.25 | V | | Power Consumption | 550 | 750 | mW |
Specifications
| Standard | IEEE 802.3 | | Topology | Bus or Star | | Protocol | CSMA/CD | | Dip switch | PROM type select | | UTP/STP cabling | CAT 3 or 5 | | LED Indicators | Link, Tx / Rx, collision |
Support Settings
| IRQ | 2/9, 3, 4, 5, 10, 11, 12, 15 | | I/O Base Address | 200, 220, 240, 260, 280, 2A0, 2E0, 300, 320, 340, 350, 360, 380, 3A0, 3C0, 3E0 | | Boot PROM Base Memory | C000, C400, C800, CC00, D000, D400, D800, DC00 | | Boot PROM type | 256K, 512K, 1M Flash |
Mechanical Diagram - Top/Side View (PC104-ELC)
| Note: - Pin spacing is 0.100" from center to center.
- Non-Stackthrough Bus connector is optional (Contact Factory for details).
- Dimension are in inches, +/-0.005
|
Note:
_________________________________________________________________________________________________________ Information furnished by Radicom Research is believed to be accurate and reliable. However Radicom Research assumes no responsibility for its use, or any infringement of patents or other rights of third parties which may result from its use. Radicom Research reserves the right to change circuitry at any time without notice. This document is subject to change without notice. The information contained herein is subject to change without notice. Logos, trademarks and copyrights are property of their respective owners. ^Back to top |
|
