SlimModem3™
|
|
|
|
|
Available: |
|
Pin-to-pin Compatible to Conexant SocketModem™ |
|
-40°C to +85°C Operating Temperature |
|
36.6K / 56K bps Data, Fax, Voice |
|
RoHS Compliance on Selected Models |
|
Full-Duplex Speakerphone with Microphone Input (RCSP only) |
|
IEC60601 Medical Device, CE Marking |
|
NVRAM installed |
|
|
|
|
The SlimModem3™ family is based on Conexant’s newly developed SmartV(128) modem chipsets. New features include V.44 Data Compression and V.92, 48kbps upstream data speed for more efficient and faster data throughput. The modems also offer V.29 POS Fast-connect and reduction in power consumption. This feature-rich modem module family is fully self-contained including built-in data pump, modem controller and on-board International DAA. The SlimModem3™ is designed as a drop-in replacement for Conexant’s SocketModem™. Standard features of the modem include data rates up to 56 kbps, 14.4 kbps fax, voice playback and recording. The modem also provides enhanced features such as Caller ID, Extension Pick-up detect, Remote Hang-up, DLG (Digital Line Guard) protection and 2nd Ring Detect. The 2nd Ring Detect feature allows a method for ring detection to control zero (0) modem power operation, ideal for battery based systems. Features:
-40°C to +85°C operating temperature
Supports 3.3V to 5V operation
Serial TTL Interface
AT Command set
300 bps to 56K bps data speeds
Up to 56 kbps data speeds downstream (V92 models)
Up to 48 kbps data speeds upstream (V92 models)
14.4 kbps Fax – Class 1
Voice playback and recording (TAM)
Concurrent DTMF, distinctive ring and caller ID
-
V.42 LAPM and MNP2-4 error correction
V.44 data compression
V.42bis and MNP-5 data compression
V.29 FastPOS support
Low Power Sleep mode
-
Line-in use detection
Call waiting detection
Extension pick-up detection
Digital Line Guard (DLG) Protection
2nd Ring Detect
Agency approvals:
Transferable FCC68, CS03 and CTR21 certified
EN55022B, EN55024
c/UL60950 Recognized, EN60950-1, IEC60950-1
-
EN60601-1, IEC60601-1 (Medical Electronics)
CE Marking
Countries supported by existing firmware:
Australia, Austria, Belgium, Brazil, Canada, China, Denmark, Finland, France, Germany, Greece, India, Ireland, Italy, Japan, Korea, Malaysia, Mexico, Netherlands, Norway, Poland, Portugal, Singapore, South Africa, Spain, Sweden, Switzerland, Taiwan, UK, US and TBR21 Generic. Ordering Information
Model No. |
Data |
Fax |
Voice |
Speakerphone |
RoHS - CE Mark |
336SM3-RC |
33.6k bps |
14.4k bps |
Yes |
No |
Yes |
V92SM3-RCSP |
56k bps |
14.4k bps |
Yes |
Yes |
Yes |
Ratings @ 25o C
Parameter |
Min |
Typ |
Max |
Units |
Tip / Ring Current Continuous |
10 |
20 |
120 |
mA |
Dielectric Withstanding Voltage |
|
|
1500 |
VRMS |
Operating Temperature |
-40 |
|
+85 |
°C |
Relative Humidity (non-condensing) |
10 |
|
95 |
% |
Voltage Requirement:
5V system |
4.75 |
5 |
5.25 |
VDC |
- Power Consumption:
Regular |
|
370 |
|
mW |
- Current Consumption:
Sleep
Mode
|
|
23 |
|
mA |
Voltage Requirement:
3.3V system |
3.15 |
3.30 |
3.45 |
VDC |
- Power Consumption:
Regular |
|
218 |
|
mW |
- Current Consumption:
Sleep
Mode
|
|
20 |
|
mA |
Transmit & Receive Level |
-10
(Tx) |
-20 |
-43
(Rx) |
dBm |
Mechanical Diagram & Pin Assignments - 336SM3-RC/V92SM3-RCSP Note:
Pin 3 to pin 23 and pin 42 to pin 60 are not provided.
Pin 25 is an open collector for the 2nd Ring Detect option
Tolerance in mechanical dimension is +/-0.002"
-
*Microphone and speaker2 pins are for the RCSP model only
-
Suggested mating female connectors:
Through Hole: |
a. Samtec P/N. #SQT-132-01-L-S (RoHS) |
SMT: |
a. Samtec P/N. #MMS-132-02-L-SV (RoHS) |
______________________________________________________________________________________________________ Information furnished by Radicom Research is believed to be accurate and reliable. However Radicom Research assumes no responsibility for its use, or any infringement of patents or other rights of third parties which may result from its use. Radicom Research reserves the right to change circuitry at any time without notice. This document is subject to change without notice. The information contained herein is subject to change without notice. Logos, trademarks and copyrights are property of their respective owners. |
^Back to top |
|